Installation Instructions 125 MAX DD2 evo
Page 23/70
Edition 09/2016
Fig. 18
Æ
Remove the isolation tape from the shift contact wire (pos. 1) and loosely fasten with
a tie wrap (pos. 2) (about 130 mm from the cable lug). See Fig. 19
Fig. 19
¿
Note:
Do not tighten the tie wrap yet in order to be able to change its position later on.
Æ
Fasten the cable lug to the shift contact assy using the Plastite screw M6x25 (pos.
3). Pay attention to correct sequence of components! See Fig. 20.
¿
Note:
Fasten the cable lug (pos. 2) between the fuel tube 8 mm (pos. 4) and the Plastite
screw M6x25 (pos. 3).
Fig. 20
Æ
Fasten the wire of the shift contact assy with a tie wrap (Pos. 1) on the bottom of the
engine.
