BRP LYNX Radien 2019, Operator'S Manual

Page: 21 / 229

RIDING THE VEHICLE
4. Check fuel and injection oil (if applicable) for levels and leaks. Re-
plenish if necessary and in case of any leaks; you should seek ser-
vice from an authorized Lynx dealer, repair shop, or person of your
own choosing for maintenance, repair, or replacement.
5. All storage compartments must be properly latched and they
must not contain any heavy or breakable objects. Hood and side
panels must be also properly latched.
6. Activate the throttle control lever several times to check that it op-
erates easily and smoothly. It must return to idle position when
released.
7. Activate the brake lever and make sure the brake fully applies be-
fore the brake control lever touches the handlebar grip. It must
fully return when released.
8. Apply parking brake and check if it operates properly. Leave park-
ing brake applied.
9. Inspect drive belt condition and height, refer to DRIVE BELT in
MAINTENANCE PROCEDURES
.
After Engine is Started
For proper engine starting procedure, refer to the appropriate
EN-
GINE STARTING PROCEDURE .
1. Check headlights high beam and low beam, taillight, stop light
and pilot lamps operation.
NOTE: You may need to detach tether cord from your clothes to
check lights. In such a case, attach cord as soon as you get back at
the controls of the snowmobile.
2. Check the engine cut-off switch (by pulling tether cord cap) and
emergency engine stop switch operation.
3. Release parking brake.
4. Refer to VEHICLE WARM UP
and follow instructions.
18
____
SAFETY INFORMATION
____