BRP LYNX Radien 2019, Operator'S Manual

Page: 110 / 229

BASIC PROCEDURES
NOTICE
If vehicle does not move when throttle is applied, stop
engine, remove tether cord cap from the engine cut-off switch,
then do the following.
– Check if skis are stuck on the ground. Lift one ski at a time by
the handle, then put it down.
– Check if track is stuck on the ground. Lift rear of snowmobile
enough to clear track from the ground, then drop.
– Check rear suspension for hard snow or ice accumulation that
could interfere with track rotation. Clean the area.
CAUTION Beware of injuries by using proper lifting tech-
niques, notably using your legs force. Do not attempt to lift the
rear of vehicle if it is above your limits.
WARNING
Make sure tether cord cap is removed before standing in front
the vehicle, getting close to the track or rear suspension com-
ponents.
NOTE: Warm-up is electronically controlled. During this period (up
to 10 minutes depending on ambient temperature), engine RPM is
limited.
Reverse (RER)
When the engine is running, depressing the RER button will slow
down engine RPM to almost a stop and advance the ignition timing
to invert crankshaft rotation.
– Engine will automatically shift into forward when restarting after
stopping or stalling.
– Shifting procedure will take place only when the engine is run-
ning.
– If engine is running at a speed above 4300 RPM, the function of
the RER button is disabled.
– It is recommended to warm up the engine to its normal operating
temperature before shifting.
Shifting in Reverse
1. Bring vehicle to a complete stop.
_________________
107