BRP LYNX Commander 800R E-TEC Touratech, Operator'S Manual

Page: 66 / 148

FUEL AND OIL
WARNING
– Always stop engine before refu-
eling. Open cap slowly.
– If a differential pressure condi-
tion is noticed (whistling sound
heard when loosening fuel tank
cap) have vehicle inspected
and/or repaired before further
operation.
– Fuel is flammable and explosive
under certain conditions.
– Never use an open flame to
check fuel level.
– Never smoke or allow flame or
spark in vicinity.
– Always work in a well-ventilated
area.
– Never top up the fuel tank be-
fore placing the vehicle in a
warm area. As temperature in-
creases, fuel expands and may
overflow.
– Always wipe off any fuel
spillage from the vehicle.
NOTE: Do not sit or lean on seat when
fuel tank cap is not properly installed.
Recommended Oil
RECOMMENDED INJECTION OIL
XPS SYNTHETIC 2-STROKE OIL(F)
(P/N 619 590 106)
NOTICE
The engine of this snow-
mobile has been developed and val-
idated using the recommended BRP
XPS™ oil. BRP recommends the
use of its recommended XPS oil or
equivalent. Damages caused by oil
which is not suitable for this oil in-
jected 2-stroke direct fuel injection
engine may not be covered by the
BRP limited warranty.
Injection Oil Level
Verification
The injection oil reservoir is located
behind the RH side panel. See
CON-
TROLS, INSTRUMENTS AND EQUIP-
MENT
for opening procedure.
Always maintain a sufficient amount of
recommended injection oil in the injec-
tion oil reservoir.
fmo2012-003-012_a
TYPICAL
1. Injection oil reservoir
2. Level marks (1/4, 1/2, 3/4)
NOTICE
Check level and refill ev-
ery time you refuel.
To Add Injection Oil
Remove injection oil reservoir cap.
Add injection oil.
Reinstall cap and fully tighten.
NOTE: Do not overfill. Do not pass
the MAX range in the reservoir filler
neck.
NOTICE
Do not mismatch oil
reservoir cap with fuel tank cap.
WARNING
Wipe off any oil spills. Oil is highly
flammable when heated.
64
______________