BRP CAN-AM OUTLANDER 6x6 2017 Series, Operator'S Manual

Page: 103 / 204

EQUIPMENT
sfvmo2014-001-003_a
1. Glove box
Maintenance, repairs and adjustments
which are not described in this
OP-
ERATOR'S GUIDE
require the use of
special tools and exact technical data
. For such work, you should contact
your dealer who has specially trained
personnel to help you.
8) Winch
The winch can be actuated using the
winch control switch or with the re-
mote control (sold separately).
NOTE: Using the winch intensively
over a long period of time may dis-
charge the battery.
The following tips will help to reduce
the risk of discharging the battery:
Always unreel manually: Unlock the
cable using the handle then pull on the
hook strap to unreel.
It is recommended to let the vehicle
run while winching. Do not stop vehi-
cle immediately after winching to let
battery recharge.
Also, when winching for more than
30 seconds, it is recommended to in-
crease engine RPM in the range of
3000 RPM to increase charging power
to the battery.
NOTE: Make sure vehicle is in NEU-
TRAL (N) before increasing engine
RPM.
Refer to
BASIC GUIDE TO WINCHING
TECHNIQUES
for more information
about the winch.
To power up the vehicle without start-
ing the engine, refer to
WAKING UP
THE ELECTRICAL SYSTEM
9) Roller Fairlead
The roller fairlead is used to prevent
damages to the vehicle and guide the
wire rope into the winch.
219001733-002_a
1. Winch
2. Roller fairlead
3. Winch hook
4. Hook strap
10) Cargo Bed
The vehicle is equipped with a 2
level inclinable cargo bed. The cargo
box/bed may be used for various types
of cargo.
WARNING
To reduce the risk of loss of control
or loss of load, use the cargo bed
only in accordance with
CARRY-
ING LOADS
in the
SAFETY INFOR-
MATION
section.
11) Cargo Bed Tilt Release
Handle
The latching mechanism of the cargo
bed can be actuated from right side of
the vehicle through a release handle.
To Tilt Cargo Bed
Release the hairpin clip.
______________
101