9
lit. The device will break the circuit automatically, and the LED light will go out.
2.
Pressing the button (3) enables the air removal functions. The green LED light will become lit. Automatic
sealer switching function (a specific vacuum level is achieved in air removal). After the sealing functions is
switched, the red LED light will become lit, while the green one will go out. Once the sealing is finished (after
5 seconds), all the functions are stopped, and the devices goes into the standby mode.
3.
Always wait 15 seconds before sealing the next bag.
4.
Use special bags, and when the food packed takes two thirds of a bag (having the size of 28 cm x 30 cm),
it is recommended for the device to work for less than 25 seconds.
5.
Press the button (2) to finish all the functions and activate the standby mode.
Button numbering
(1) (2) (3)
SEALING (1) STOP (2) AIR REMOVAL AND SEALING (3)
HOW TO USE:
Familiarising yourself thoroughly with the recommendations below will enable using the sealer properly and enjoy its
faultless functioning for a longer time.
1. Switch the power on and open the cover.
2.
Place the edge of the film sleeve in the sealer’s groove.
3. Close the cover and lock it by pressing it on both sides until you hear a click. Press the button (1) of the bag
sealing function. A red LED light should become lit, and then it should go out once the sealing is complete.
4.
Once the bag’s edge is sealed, press the buttons on the sides of the device in order to unlock the cover.
5. Remove the sleeve sealed and then adjust its length to the element being packed.
6.
Once you choose the right length of the bag, draw aside the rear guide of the sealer’s knife, and place the film
between the guide and the back of the device.
7. Close the guide again by pressing it to the back of the sealer and then pull through the length of the film sleeve
than you want to cut off.
8. With a quick and decisive move, pressing gently, slide the knife built into the plastic guide and cut the film.
9.
Once you have the right length of the bag cut off, place products inside of it
(in the amount that does not
exceed ¾ of the bag’s capacity).
10.
Place the edge of the bag in the sealer’s groove and close the cover (step 3).
11. Press the button (3) of the automatic air removal and sealing function. The green LED light will become lit.
12. After the set pressure is achieved, the green LED light will turn red, and the sealing starts.
13. Once the red LED light goes out, the air removal process is finished.
14.
In order to stop the process, press the Stop button.
15. Press the buttons on both sides of the cover in order to open it and remove the sealed bag.
Problems and solutions
The list of common problems and solutions to them is provided below.
Symptoms
What to check:
The device is not
working.
Whether the power supply cable is plugged into the mains socket.
Whether the plug is not damaged.
Whether the device has not been used too long without a break.
The device does not
seal.
Whether the bag is not crumpled or placed in uneven manner – adjust its
placement in the device if necessary.
Whether the cover is shut properly.
Hold the button and check whether the LED light becomes lit.
Whether the resistance wire is undamaged.
The device does not
vacuum seal.
Whether the bag’s edge is put correctly into the device.
Whether the bag is not crumpled – straighten it out if necessary.
Whether the bags are undamaged.
Whether the bag is not overfilled (above 3/4 of capacity).
Whether the air removal works.
Whether appropriate bags are used.
Whether the seam is undamaged on both sides.