BW1253s User Guide v1.0
Nov. 2013
Page 54 of 180
Reboot
– click the button to restart the server and apply the changes
If there is no other settings needed to be modified, click the
Reboot
button to apply all
changes. If there are any other settings need to be changed, continuously to finish and
apply all changes and then click
Reboot
button to restart and take effect for all settings.
Wireless | Layer 2 Isolation(Inter-BSS)
Use the
Layer 2 Isolation
service to block inter-BSS communication of all users. Users can only
access the AP connected, the gateway and devices in the allow MAC List.
Please go to
Wireless | Advanced
page to configure intra-BSS communication of
users in the same BSS. Full layer 2 isolation need to set both intra-BSS and inter-
BSS layer 2 isolation.
The
Wireless
|
layer 2 isolation
setting page is only exist in AP mode as it is only
for inter-BSS layer 2 isolation. There is no
Wireless
|
layer 2 isolation
setting page
in AP-Router mode.
Figure 72 – layer 2 Isolation Service
Edit
– edit the layer 2 isolation settings.
To change layer 2 isolation setting properties click the
Edit
button.
Figure 73 – layer 2 Isolation Setting
Status
–select status from the drop-down menu.
disable
– disable the layer 2 isolation (Inter-BSS) service.
enable
– enable the layer 2 isolation (Inter-BSS) service.
Only when Inter-BSS Isolation is enabled, the entry of the allowed MAC list can be added.
Figure 74 –Allowed MAC List
