Brouwer 1570, Operator'S Manual

Page: 50 / 66

OPERATION
Guide Shoe Adjustment.
The Guide Shoe must be correctly adjusted as
follows :

Loosen the Yoke Clamp Bolt ‘ A ’, and rotate the
Guide
Shoe ‘
B ’, until there is ¼ inch clearance
between the
inside edge of the shoe and the ground.

Tighten the Yoke Clamp bolt.
Re-Set Cylinder Chain Adjustment.
The Re-Set Cylinder ‘
C ’, must be attached to the
chain at a point that allows the Guide Shoe to travel
no more than
2 to 4 inches past the ‘cut edge’
onto the uncut turf.
IMPORTANT
The Reset Cylinder chain links must be adjusted
before the adjustment to the Stop Bolt. See below.
STOP BOLT ADJUSTMENT.
The Stop Bolt ‘
D ’, determines where the Guide Shoe
will ‘drop’ on the ground when the Auto-Steer is
activated.
For most harvesting conditions the Stop Bolt is
adjusted to position the Guide Shoe 1 to 2 inches
away from the ‘cut edge’.
If the conditions require adjustment to the Guide
Shoe :
‘Away’ from the cut edge :

Back-off the Locknut and turn the Stop Bolt ‘ IN ’.
‘Closer’ to the cut edge :

Turn the Stop bolt ‘ OUT ’.
After adjustment
fully tighten the Locknut.
4-13