Z-8550A, 8560A
15. TROUBLESHOOTING
77
Problem Possible
cause
Page
9 Lower thread is tangled at
the sewing start.
Spinning of bobbin during
thread trimming
•
Is the bobbin spinning direction correct when the lower thread is
being pulled?
Set the bobbin so that it turns in the opposite direction to the
rotary hook.
•
Is there too much thread
wound onto the bobbin?
The bobbin winding amount
should not be more that
80 %.
•
Is the anti-spin spring attached? (8560A)
Attach the anti-spin spring.
•
Is the bobbin turning smoothly?
If the bobbin is not turning smoothly, replace the bobbin.
•
Is a bobbin other that the light-alloy bobbins specified by Brother
being used? (8560A)
Use only bobbins which are specified by Brother.
16
16
15
15
10 Upper and lower threads
are breaking.
•
Is the needle bent or is the needle tip broken?
Replace the needle if it is bent or broken.
•
Is the needle properly installed?
If it is incorrect, install the needle correctly.
•
Is the machine properly threaded?
If it is incorrect, thread the thread correctly.
•
Is the rotary hook sufficiently lubricated?
If the oil gauge is down to the lower reference line in the oil
gauge window, add more oil.
•
Is the upper or lower thread tension too weak or too strong?
Adjust the upper thread or lower thread tension.
•
Is the upper thread may be loose because the thread take-up
spring operating range is too small?
Adjust the position of the thread take-up spring.
•
Is the needle and rotary hook timing incorrect?
Adjust the height of the needle bar.
Adjust the clearance between the needle and the rotary hook.
•
Is the thread too thick for the needle?
Use the correct needle or the correct thread.
•
Is the rotary hook, bobbin case, thread take-up lever or some other
part in the thread path damaged?
Repair the damage, or replace the part with a new one.
15
17
9
47
61*
64*
64*
*
11 Broken
needles
•
Is the material being pushed or pulled with excessive force during
sewing?
•
Is the needle properly installed?
If it is incorrect, install the needle correctly.
•
Is the needle bent, is the needle tip broken, or is the needle hole
blocked?
Replace the needle.
•
Is the needle and rotary hook timing incorrect?
Adjust the height of the needle bar.
Adjust the clearance between the needle and the rotary hook.
•
It is extremely dangerous to leave any pieces of broken
needle sticking in the material. If the needle breaks, search
for all pieces until the whole of the needle is found again.
•
Furthermore, we recommend we recommend that through
steps be taken to account for such needles to comply with
product liability regulations.
15
64*
64*
Lower
thread
0628M
3557M
0471M
Caution
0469M
