3. INSTALLATION
3-4-2. Other cords
DANGER
Wait at least 5 minutes after turning off the power switch and disconnecting the power cord from the wall outlet
before opening the cover of the control box. Touching areas where high voltages are present can result in severe
injury.
For Europe specifications, Americas 220V specifications and 100 V/400 V system specifications, connect the cords according
to the respective specifications.
< Europe specifications >
(1) Filter box
(2) Screws [4 pcs]
(3) Connector
(4) CE bush plate
(5) Screws [2 pcs]
(6) CE D cord cover
(7) Screws [2 pcs]
(8) Staples [5 pcs]
(9) Power cord
1. Attach an appropriate plug to the
power cord (9). (The green and
yellow wire is the ground wire.)
2. Insert the power plug into a
properly-grounded electrical outlet.
NOTE:
・
Take care when tapping in the
staples (8) to make sure that they
do not pierce the cords.
・
Do not use extension cords,
otherwise machine operation
problems may result.
0943D
Green and yellow wire (ground wire)
Control box
Leg
<Seen from underneath table>
S-7300A
10
