X
Error messages
Troubleshooting
Message
Cause / Remedy
Battery
Low
!
The batteries are weak.
If using AAA alkaline batteries,
replace them with new ones (do not
use a combination of old and new
batteries).
If using Ni-MH batteries, charge
them fully.
Battery
Empty!
The installed batteries are
exhausted and need to be replaced
for continued operation.
Invalid!
• An invalid number was entered as
the label length, tab length, cable
diameter, flag length or faceplate
length.
• An invalid letter or number to be
incremented was selected in the
Serialize function.
No Text
!
• You tried to print a text file when
there is no data stored in the
memory.
•
is pressed when no text is
entered.
•
+
is pressed when no
text is entered.
•
is pressed when no text is
entered.
•
or
was pressed when no
text was entered while using
templates.
2 Line
Limit!
/
1 Line
Limit!
• You tried to enter a 3rd line by
pressing .
• You tried to print or preview two
lines of text while 0.13" (3.5mm) or
0.23" (6mm) tape is installed. Install
a larger tape size.
No
Cassette!
There is no cassette installed.
Install a cassette with the
mark.
Message
Cause / Remedy
Cutter
Pressed
The Tape Cutter Lever was pressed
in the middle of the printing process.
Text
Full!
The maximum number of characters
(80 characters for text) have already
been entered.
Text
Limit!
Change
Length
You may have exceeded the set
tape length. Reduce the text or
select [
Auto
] as the tape length.
Feed OK?
• Feeding tape after printing when
[
Chain Print
] is selected. Refer
to the
Setting Margins
section in
this guide.
Wrong
Tape!
Use TZe
tape
• Use a cassette with the
mark.
