Brother LX-200, Service Manual

Page: 38 / 177

3-18
3.6.2 Disassembling the T-Chassis Unit
1.Open hook A on the T-paper guide in the direction A'. Pull out the T-lever shaft to
remove the T-lever unit.
2.Remove T-lever 2 from T-lever 1. Remove the T-push spring and T-cam roller.
3.Remove the leaf switch TRI screw and remove the leaf switch TRI assy.
4.Disconnect the switch lever from the shaft hook on the T-paper guide and remove
the switch lever.
5.Remove the T-cutter upper unit from the T-paper guide. Remove the T-cutter
stopper from the T-cutter holder, then remove the T-cutter.
6.Remove the paper guide screw and remove the T-paper guide.
7.Remove the leaf switch TRG screw and remove the leaf switch TRG assy.
8.Turn the T-sensor lever until lug A aligns with the slot in the T-chassis and
remove the T-sensor lever.
9.Disengage hook B on the T-cam gear. Pull out the T-cam shaft to release T-gear
35-14 and T-idle gear.
T-cutter holder
T-cutter stopper
T-cutter upper unit
T-sensor lever
Leaf switch TRG screw
Leaf switch TRG assy
Leaf switch TRI screw
Leaf switch TRI assy
Paper
guide
screw
Switch lever
Shaft hook
T-paper guide
T-cutter
Hook A
T-lever 1
Lug “A”
T-push spring
T-lever unit
T cam roller
T-lever 2
Hook B
T-cam gear
Slot
T-cam shaft
T-gear 35-14
T-idle gear
T-lever shaft
T-chassis
A ’
Fig. 3.6-2 Disassembling the T-Chassis Unit