60
DH4-B981
9. STANDARD ADJUSTMENTS
Adjust the cutting pressure to the minimum pressure that still allows the material to be cut.
* If the knife cutting length is 20 mm, sufficient cutting performance can be obtained with an air pressure of 0.2 MPa.
*
To adjust the cutting pressure, adjust the air pressure of the knife pressure adjustment regulator
q
which is mounted
*
underneath the work table.
* If the cutting pressure is increased to more than is
*
necessary, it will cause the hammer to become worn or
the knife to become damaged.
* If the material cannot be cut cleanly, do not increase the
cutting pressure over the maximum limit. Check the
*
contact between the knife and the hammer, while
referring to "9-11. Adjusting the contact between the knife
and the hammer".
q
9-13. Adjusting the cutting pressure
9-12. Replacing the knife
After checking that there is no clearance between the stopper plate
q
and the knife
w
, loosen the bolt
e
and then
remove the knife
w
.
Insert the new
w
into the stopper plate
q
, and then tighten it with the bolt
e
.
NOTE: For L1 - L4 specifications, secure the stopper plate
q
in the position closest to you (the position indicated by
the dotted lines).
* When replacing the knife
w
, make sure that the knife number matches the number for the eyelet shape.
*
Replace the knife and hammer as a set.
*
If knives with different numbers are used on the same hammer, accurate cutting will not be possible, and
*
damage to the knife may result.
e
q
w
(L1 - L4)
0974Q
0975Q
0973Q