37
DH4-B981
6. USING THE OPERATION PANEL
I. Setting the mode
1. Turn off the power.
2. Change the settings for panel DIP switch C No. 1 and
2.
No. 2 to set the desired mode.
3. Turn on the power.
* Feed mode is used to move only the feed bracket
*
without sewing, in order to check the position of the article.
* Manual mode is used when sewing while turning the
*
upper shaft by hand, in order to check operation.
* Automatic mode is used when carrying out sewing.
J. Setting panel protection
1. Turn off the power.
2. Change the settings for panel DIP switch C No. 3 to
2.
set the desired condition.
3. Turn on the power.
K. Setting the cloth setting position (-52 specifications)
1. Turn off the power.
2. The cloth setting position can be set to either left setting
2.
or horizontal setting.
2.
Setting is possible when the cloth setting bar is at the
2.
left setting position.
3. Change the settings for panel DIP switch C No. 6 to
3.
set the desired cloth setting position.
4. Turn on the power.
4.
* When set to the left setting position, cloth setting is
4. *
always carried out at the left setting position.
4.
* When set to the horizontal setting position, cloth
4. *
setting is carried out at both the left and right setting
4. *
positions.
No. 3
Condition
Changing cutting on/off,
stitch length settings prohibited
Changing cutting on/off,
stitch length settings allowed
ON
OFF
ON
OFF
No. 6 Cloth setting position
Left setting
Horizontal setting
No. 1 No. 2
Mode
Feed mode
Manual mode
Automatic mode
ON
OFF
OFF
ON
OFF
OFF
OFF
1
2
3
4
5
6
7
8
C
OFF
1
2
3
4
5
6
7
8
C
OFF
1
2
3
4
5
6
7
8
C
0916Q
0917Q
0918Q
