Brother DCP-J4110DW, Basic User'S Manual

Page: 64 / 123

56
Ink Absorber Full
The ink absorber box or flushing box is
full. These components are periodic
maintenance items that may require
replacement after a period of time to
ensure optimum performance from
your Brother machine. Because these
components are periodic maintenance
items, the replacement is not covered
under the warranty. The need to
replace these items and the time
period before replacement is
dependent on the number of purges
and flushes required to clean the ink
system. These boxes acquire
amounts of ink during the different
purging and flushing operations. The
number of times a machine purges
and flushes for cleaning varies
depending on different situations. For
example, frequently powering the
machine on and off will cause
numerous cleaning cycles since the
machine automatically cleans upon
power up. The use of non-Brother ink
may cause frequent cleanings
because non-Brother ink could cause
poor print quality which is resolved by
cleaning. The more cleaning the
machine requires, the faster these
boxes will fill up.
NOTE
Repairs resulting from the use of
non-Brother supplies may not be
covered under the stated product
warranty.
The ink absorber box or flushing box
will need to be replaced. Contact
Brother Customer Service or your
local Brother Authorised Service
Centre to have your machine serviced.
Other reasons for cleaning are:
1 After a paper jam has been
cleared, the machine automatically
cleans itself.
2 The machine automatically cleans
itself after sitting idle for more than
30 days (infrequent use).
3 The machine automatically cleans
itself after ink cartridges of the
same colour have been replaced
12 times.
InkAbsorberNearFull
The ink absorber box or flushing box is
nearly full. Call Brother customer service or your
local Brother dealer.
Ink low
One or more of the ink cartridges are
near the end of their life. Order a new ink cartridge. You can
continue printing until the
Touchscreen shows
Cannot Print
.
(See Replacing the ink cartridges
on page 47.)
Low Temperature
The print head is too cold. Allow the machine to warm up.
Error Message Cause Action