10
1
ON/OFF SWITCH
To turn on the
vacuum cleaner,
move the switch on
the appliance to
the “ON” position.
(Fig. 18)
To turn off the
vacuum cleaner,
move the switch
to the “OFF” po-
sition. (Fig. 19)
2
Fig.18
Fig.19
NOTE:
Fig.20
1
2
RUG /FLOOR SELECTOR
(CT1500 only)
Make sure the RUG / FLOOR selector is set to either the extreme front or the
extreme back to avoid any problems that may occur.
When cleaning carpets, slide the selector to the “RUG”
position.
When cleaning bare floors, slide the selector to the “FLOOR”
position. (Fig. 20)
The agitator will not rotate when the selector is in the FLOOR
position.
The RUG / FLOOR selector should only be adjusted while the
vacuum cleaner is turned “ON” and in the upright position.
HEAT PROTECTION SYSTEM
This vacuum cleaner has a special thermostat that protects the motor from overheating. If the
vacuum cleaner suddenly shuts off, push the (ON/OFF) switch to the (OFF) position and
unplug the cleaner. Check the vacuum cleaner for a possible source of overheating such as
a full dirt compartment or clogged filters. If these conditions are found, empty the dirt
compartment and clean the filters (see pages 10, 11) or replace if necessary (see page 13).
To maintain the best performance of your vacuum cleaner, we recommend emptying the dirt
compartment before the dirt reaches the “Max Fill Line” and clean the filters.
OPERATING INSTRUCTIONS
ON
OFF
ON/OFF Switch
ON/OFF Switch
CT1200/CT1500Layout
1.3.8, 4:02 PM
10
