Brother 888-G30, Operation Manual

Page: 57 / 124

Utility Stitches
55
V
A
R
IOU
S ST
IT
C
H
ES
3
h
Remove the flat bed attachment to use the free arm.
i
Slide the item that you wish to sew onto the free arm,
make sure that the fabric feeds correctly, and then start
sewing.
j
Position the fabric with the edge of the folded hem
against the guide of the presser foot, and then lower
the presser foot lever.
k
Adjust the stitch width until the needle slightly catches
the fold of the hem. (page 38)
When you change the needle drop point, raise the
needle, and then change the stitch width.
* To make fine adjustments to the needle drop point,
adjust the stitch width setting. (The stitch width
setting is in neither millimeters nor inches.)
l
Sew with the fold of the hem against the presser foot
guide.
m
Press the “Start/Stop” button to stop sewing when you
are finished, and raise the presser foot and needle to
pull the fabric under the presser foot towards the back
of the machine.
n
Remove the basting stitching and turn the fabric with
the right side facing out.
1
Free arm
1
Wrong side of
fabric
2
Fold of hem
3
Guide
1
Needle drop point
1
Thick fabric
2
Normal fabric
Memo
• Blind hem stitches cannot be sewn if the left needle
drop point does not catch the fold. If the needle
catches too much of the fold, the fabric cannot be
unfolded and the seam appearing on the right side
of the fabric will be very large, leaving an
unattractive finish.
a
a
b
Note
• Be sure to pull the fabric towards the back of the
machine after sewing. If you pull the fabric toward
side or forward, the presser foot may be damaged.
1
Wrong side of
fabric
2
Right side of
fabric
1 2