Attaching the Embroidery Frame
47
1
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
Attaching the Embroidery Frame
This section describes how to attach the embroidery frame.
Attaching the embroidery frame
a
Wind the embroidery bobbin thread onto the
bobbin and set it into the bobbin case.
• For details, refer to "Winding/Installing the
Bobbin" (page 29).
b
Raise the presser foot lever.
a
Presser foot lever
c
Press
(Needle position button) once or
twice to raise the needle.
a
Needle position button
d
Pass the embroidery frame under the presser
foot while raising the presser foot lever even
further.
CAUTION
e
Firmly insert the embroidery frame guide into
the embroidery carriage frame holder from the
top.
Line up the embroidery frame guide tabs and
the embroidery carriage frame holder slots and
push in until it clicks and stops.
a
Embroidery frame guide tabs
b
Embroidery carriage frame holder slots
X
The embroidery unit is attached.
Note
z
Be sure to insert both pins. If only the
forward or the back pin is inserted, the
pattern may not turn out correctly.
CAUTION
●
Do not touch the start/stop button or
needle position button. If one of the
buttons is accidentally pressed, the
machine will move and your finger may
be pricked with the needle or the needle
may break.
a
a
●
Correctly set the embroidery frame into
the embroidery frame holder. Otherwise,
the embroidery foot may hit the
embroidery frame, resulting in injury.
a
b
0711-0120-C-combo_E.book Page 47 Thursday, July 24, 2008 1:46 PM
