NAMES OF MACHINE PARTS AND THEIR FUNCTIONS
3
Operation Buttons
a
“Start/Stop” button
Press this button and the machine will sew a few stitches at a
slow speed and then begin sewing at the speed set by the
sewing speed controller. Press the button again to stop the
machine. Hold the button in to sew at the machine’s slowest
speed. The button changes color according to the machine’s
operation mode.
b
“Reverse/Reinforcement Stitch” button
Use this button to sew reinforcement stitches at the beginning
and end of sewing. Press this button, and the machine sews 3
stitches in the same spot and stops automatically. For straight
and zigzag stitch patterns that take reverse stitches, the
machine will sew reverse stitches at low speed only while
holding down the “Reverse/Reinforcement Stitch“ button (the
stitches are sewn in the opposite direction).
c
“Needle Position” button
Use this button when changing sewing direction or for detailed
sewing in small areas. Press this button to raise or lower the
needle position. Press the button twice to sew a single stitch.
d
“Thread Cutter” button
Press this button after sewing to automatically trim the excess
thread.
e
“Presser Foot Lifter” button
Press this button to lower the presser foot and apply pressure to
the fabric. Press this button again to raise the presser foot.
f
Sewing Speed controller
Use this controller to adjust the sewing speed. Move the slide to
the left to sew at slower speeds. Move the slide to the right to
sew at higher speeds. Beginners should sew at a slow speed.
g
“Automatic Threading” button
Use this button to automatically thread the needle.
Included Accessories
Pull the top of the flat bed attachment to open the
accessory compartment.
a
Storage space
b
Presser foot storage space
c
Presser foot storage space
Included Accessories 31-34 are contained in the
embroidery unit carrying case. To open the
embroidery unit carrying case, unhook the two
latches on the case. To re-hook the latches and
securely close the case, press on the latches until
each of them clicks.
a
Latches
Green:
the machine is ready to sew or is sewing.
Red:
the machine cannot sew.
CAUTION
• Do not press the thread cutter button after the
threads have already been cut. Otherwise, the
needle may break, the threads may become
tangled, or damage to the machine may occur.
a
c
b
a
Summary of Contents for 882-S90/S91
