Brother Industries SUPER ACE+e, Service Manual

Page: 12 / 56

-10-
8. Remove the presser holder and needle.
9. Remove the 14 connectors, the two screws, and the main PC board.
10. Remove the two screws and handle holder assembly.
11. Remove the screw and thread winding assembly.
12. Remove the motor belt and pull out the motor connector. Remove the two screws and the main motor.
13. Remove the screw and the board set plate D.
14. Remove the side feed plate spring, the three screws and the SPM holder.
15. Remove the two screws, and pull out the thread guide cover from the tension link.
16. Remove the screw and the H block shaft holder assembly.
17. Remove the three springs and the needle bar block assembly.
18. Remove the two screws and the ZPM assembly.
Disassembly Points
9. To disconnect the connectors, grab the base of the connector and pull it straight out.
∗
In order to reduce the risk of static electric damage to the main PC board after it is removed from the
sewing machine, do not touch the board’s front surface and only carry it by its edges in the same way
that you hold a compact disk.
15. To remove the thread guard cover from the tension link more easily, cut the band.
15. Before removing the thread guard cover from the tension link, lower the presser foot lifter and move part
(A) of the thread take-up crank so that its front slants upward.
16. To remove the needle bar supporter stud holder, move it upward while removing it from the pin.
17. Before removing the needle bar supporter assembly, remove the two springs (B).
18. Before removing the ZPM holder assembly, remove the lamp cord connector from the power supply PC
board.
www.promelectroavtomat.ru