Brother Industries SUPER ACE+e, Service Manual

Page: 23 / 56

-21-
DISASSEMBLING AND REASSEMBLING THE EMBROIDERY UNIT (OPTION)
1. Remove the screw and Y carriage cover.
2. Remove the screw, and remove the side cover from the lower side.
3. Remove the two screws and pull the main cover to the right.
4. Remove the three screws and the base cover.
Assembly Point
3. Securely fit the bottom rear part of the side cover into the base cover.
∗
If these parts do not securely fit together, the side cover may become loose and raised up.
Check to make sure that there is space between sensors on X and Y shutters.
Set X sensor lead wire and X pulse motor lead wire in section (A). Attach main frame, taking care not to
pinch cord.
Using a clip, fix Y sensor lead wire firmly in place so that there is no slack between in and section (B).
Move X carriage side to side to make certain that Y sensor lead wire and YPM lead wire do not come
into contact with main frame and main cover during movement of X carriage.
www.promelectroavtomat.ru