Broncolor Minipuls C200, Operating Instructions Manual

Page: 7 / 11

6
1. Minipuls C200
We are delighted that you have chosen the high quality product broncolor
Minipuls C200. With proper care it will render you many years of good
service.
2. Application
This mains supplied studio flash unit is designed for professional
photography only.
In countries with earthed mains systems, use a three-
wire extension cable.
3. Commissioning
3.1
Remove grey plastic hood by rotating. Insert the flash tube in accordance
to point 4 and plug in the modelling lamp. Press desired reflector and
protecting glass into the mounting and rotate in any direction.
3.2
Please check that the mains supply corresponds to the information on the
label of the unit. Connect unit to earthed power.
3.3
Switch on main switch (8) and modelling light (7).
3.4
The modelling light can be switched off or on during charging (dim
function) by pushing in switch (12) with a small screwdriver. This option
allows the photographer to confirm visually that all the Minipuls C200 units
have fired.
3.5
Set desired flash output via control knob (11).
3.6
Green control lamp (3) will illuminate: this is how the unit shows that it is
ready
3.7
Release test flash by pressing key (1).
3.8
Switch photocell (9) or infrared receiver (10) on or off.
3.9
If needed, plug in synchronous cable (2).