6
1. Application Minicom
This mains supplied studio flash unit is designed for professional photography only. In
countries with earthed mains systems, use a three-wire extension cable when required.
2. Start up
2.1 Mains
voltage
The monoblocs Minicom 40 and Minicom 80 are available in two different versions:
a) As a bi-voltage-unit, of which the technical data are optimised for a mains voltage of
200 - 240 V. If this version is operated with a mains voltage of 100 – 120 V, the
following restrictions result:
Mains voltage 120 V: doubling of the charging time
Mains voltage 100 V: doubling of the charging time as well as reduction of the
maximum flash energy of 250 J (Minicom 40) respectively
500 J (Minicom 80), extension of the flash duration by 20 %
b) As a bi-voltage-unit, of which the technical data are optimised for a mains voltage of
120 V. If this version is operated with a mains voltage of 200 – 240 V or 100 V, the
following restrictions result:
Mains voltage 230 V: doubling of the charging time
Mains voltage 100 V: Extension of the charging time by 20 % as well as a
reduction of the maximum flash energy of 250 J (Minicom 40)
respectively 500 J (Minicom 80), extension of the flash
duration by 20 %.
Attention:
The operating voltage of the modelling lamp must correspond to the mains
voltage.
2.2 Earthed
mains
Connect unit to current supply always using an earthed mains plug.
2.3 Start
up
In the proximity of the halogen lamp, the unit, depending on the accessories used, can
acquire high temperatures. For this reason, we recommend to touch the unit only on the
rear handle or on the stand adapter. Due to the intense heat radiation when a modelling
light is in operation, keep the unit at a minimum distance of 1 meter from flammable
surfaces.
1.) Remove the transparent plastic cap by turning and releasing the unlocking slide at
the same time. Insert modelling lamp and flash tube as per instructions in chapter 8.
Put on the protecting glass as well as the desired light shaper and turn in any
direction.
