6
www.bromicheating.com
!
WARNING
This Heater MUST be permanently Installed and hard
wired by an authorised/licenced person. Do Not perform
maintenance, or carry out installation or assembly
procedure while electrical power is switched on.
HEATER INSTALLATION
1. Remove warning note from front of
heater
2. Remove the wire cover by pulling it out
from under the edge of the heater and
in between the reflector
3. Remove packing material around
heating elements
4. Check element markings at both
ends of heater. Ensure marks on
heating element are in line with
marks on end cap.
5. Attach the wire cover by pushing one
side of it in between the reflector and
under the edge of the heater. Perform
the same process on the other edge of
the heater
REMOVE PACKAGING MATERIAL
All packaging material must be removed from heater before installation.
