12
bromic.com/heating
ELECTRICAL INSTALLATION
This heater MUST be permanently installed by
an authorised/licenced person. Do not perform
maintenance, or carry out installation or assembly
procedure while electrical power is switched on. To
disconnect heater, turn off power to heater circuit at
main disconnect panel .
1.
Check product label for correct voltage and
wattage to
ensure sure power source conforms to the heaters
requirements.
2. The power cable must positioned away from &
protected from the enclosure of the heater.
3. Make all connections in accordance with
local electrical code regulations. For outdoor
installation, all connections must be made in
accordance with local electrical code regulations for
outdoor wiring. Only use wiring components approved
for outdoor use with minimum IPX4 rating.
WARNING
ELECTRICAL SHOCK HAZARD! Serious injury or death
may occur. Disconnect from electrical supply before
installing or servicing this heater. Read and follow
installation clearance requirements outlined in this
manual. The appliance MUST be connected to a properly
grounded electrical source.
!
ELECTRICAL INSTALLATION
WARNING
ELECTRICAL SHOCK HAZARD!
Serious injury or death may occur. Disconnect from
electrical supply before servicing this heater.
!
MAINTENANCE
Ensure that the heating unit is not directly exposed to rain
or water contact. For longest product life, and to maintain
product appearance, mount heater under cover and protect
from rain and weather whenever possible.
The exterior housing of the heater should be cleaned
regularly. To clean the appliance; ensure heater is off, and
has been off for at least 2 hours after operation, before
wiping off any dirt/dust with a soft damp cloth.
Salt in the air can cause rusting of metal, especially at
locations near the coast. Additional cleaning of the heater
with a soft damp cloth fortnightly will aid in maintaining the
product’s appearance.
SERVICING
WARNING
Servicing and maitenance MUST be carried out by an
authorised and licenced service person only. Do not operate
any heater after it malfunctions. Disconnect power at
service panel and have heater inspected by a reputable
electrician before reusing.
!
WARNING
If the supply cord is damaged, it must be replaced by
Bromic, a service agent of Bromic or similarly qualified
persons in order to avoid a hazard. Contact Bromic for
further information on replacement of the supply cord.
!
SYMPTOM
POSSIBLE CAUSE (S)
CORRECTIVE ACTION
No heat
1. Improper connection
1. Check connection to power supply
Not enough heat
1. Heater too small for application
2. Heater mounted too high or too
far
1. Add additional heater(s)
2. Decrease mounting height or
distance
Too much heat
1. Heater too large for application
2. Heater mount too low or too close
1. Replace with smaller heater
2. Increase mounting height or
distance
TROUBLESHOOTING
For wiring instructions using Bromic Platinum Smart-Heat Electric Wireless Dimmer BH3130011-1 or ON/OFF Control
BH3130010-1 refer to instructions provided with controller.
IMPORTANT: Electronic dimmer controls generate heat during operation. For Bromic heaters installed Bromic
Smart-Heat Electric Wireless Dimmer
BH3130011-1
or ON/OFF Control
BH3130010-1
it is essential to ensure dimmers
are mounted in a clean, dry and well ventilated position with clearance on all sides. It must be ensured the dimmers
are not installed in a confined space, close to other heat generating appliances or in the case of a multi-dimmer
installation, not too close together. Dimmers must remain cool at all times. Please consult Bromic dimmer
installation instructions for further details or for further questions please contact Bromic technical support services.
WARNING
!
