4
bromic.com
IMPORTANT NOTES AND WARNINGS
WARNING
•
IMPORTANT - Installation MUST be carried out by a licensed and
authorised person.
•
DO NOT leave heaters ON unattended for prolonged use and inspect
the heating space regularly.
•
Improper installation, adjustment, or alteration and failure to follow
the warnings and instructions in this manual could result in severe
personal injury, death or property damage.
•
The manufacturer is not responsible for any damage that could
happen from improper use. The manufacturer emphasises that
this appliance should be used in a responsible manner and that
all procedures, warnings, and safety instructions contained in this
booklet should be followed strictly.
•
The installer is to ensure that the requirements of the local authority,
local electrical installation code, municipal building codes, and any
other relevant statutory regulations are carried out.
•
Do not place articles on or against this appliance.
•
To reduce the risk of fire, do not store or use gasoline or other
flammable vapours and liquids in the vicinity of the heater.
•
This Installation, Operation and Service manual should not be
removed from the site of installation. Installer should leave manual
with the customer for future reference.
•
A minimum safety distance of 1000mm (39.4”) should always be left
in front of the appliance.
•
For commercial and residential installations, this unit must be either
wall mounted at a minimum of 1800mm (71”) above the floor or
ceiling mounted at a minimum of 2400mm (96”) above the floor.
•
The appliance must not be located directly below or in front of an
electrical socket. Heat radiated from the appliance may damage the
electricity outlet or plug if placed incorrectly.
•
Any guard or other protective device removed for servicing
(conducted by an authorised person) must be replaced before
operating the heater.
•
This appliance is not intended for use by persons (including children)
with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a person
responsible for their safety.
•
Heaters are not intended to be installed in wardrobes.
•
Extreme caution is necessary when any heater is used by or near
children or invalids and whenever the heater is left operating and
unattended.
•
Children and adults should be alerted to the hazards of high surface
temperatures and should stay away to avoid burns, clothing ignition,
or other serious personal injury.
•
This heater is hot when in use. To avoid burns, do not let bare skin
touch hot surfaces. Keep combustible materials, such as furniture,
pillows, bedding, papers, clothes, etc. and curtains at least 3 feet (1m)
from the front of the heater and keep them away from the sides and
rear.
•
Keep packaging materials out of reach of children.
•
Do not spray aerosols or flammable materials in the vicinity of this
appliance while it is in operation.
•
Installation and repair must be carried out by a qualified & licenced
service person only. The heater should be inspected before use
and at least annually serviced & inspected by a qualified & licenced
service person.
•
Do not perform maintenance until heater has been turned off,
power disconnected, and heater temperature has cooled to room
temperature.
•
Clothing or other flammable materials should not be hung from the
heater or placed on or near the heater.
•
Be sure the heater is not facing the ceiling or flammable or
combustible substances/materials.
•
Do not paint any surface of the heater.
•
Certain materials or items, when stored under or near the appliance,
will be subjected to radiant heat and could be seriously damaged.
Combustible materials e.g. walls, floors, furniture, fixtures and plants
must be kept a minimum of 1000mm (3 ft) from the heater. Regularly
inspect the heating space for any materials or items that should not be
near the heater.
•
This radiant heater shall NOT be installed on recreational vehicles and/or
boats/ marine crafts.
•
Do not attempt to alter the unit in any manner.
•
Remove transit protection before use.
•
Never operate the heater in an explosive environment such as areas
where petrol or other flammable liquids or vapours are stored.
•
Check for damage to the appliance regularly. The heater must not be
used if the glass panel or any other part of the heater is damaged. If
damage to the appliance is suspected, discontinue use immediately and
contact the supplier or qualified person to repair.
•
After unpacking, make sure the appliance shows no signs of visible
damage or tampering. If the appliance appears damaged, contact the
place of purchase for assistance.
•
This appliance must only be used with the voltage as specified on the
appliance rating label.
•
Do not touch the heating glass surface at any time, even when the heater
is turned off and has cooled down.
•
Do not touch the heater with wet hands at any time.
•
If the appliance has not been used, or will not be used, for a long period
of time, disconnect power supply.
•
At the end of this product’s useful life, it must not be disposed of as
domestic waste, but must be taken to a collection centre for waste
electrical and electronic equipment. It is the user’s responsibility to
dispose of this appliance through the appropriate channels at the end
of its useful life. Failure to do so may incur the penalties established
by laws governing waste disposal. Proper differential collection, and
the subsequent recycling, processing and environmentally compatible
disposal of waste equipment avoids unnecessary damage to the
environment and possible related health risks, and also promotes
recycling of the materials used in the appliance. For further information
on waste collection and disposal, contact your local waste disposal
service, or the place of purchase.
•
In case of direct connection to a supply line, for each platinum Smart-
Heat Electric heater, a two poles or double pole residual current
device (RCD), or residual current circuit breaker (RCCB), must be
fitted upstream from the supply line; this electric wiring is designed to
quickly and automatically disconnect the appliance when it detects
that the electric current is not balanced between the supply and return
conductors to prevent electric shock.
•
In case of direct connection to a supply line, for each Platinum Smart
Heat Electric heater, a bipolar circuit breaker (CB) with contact opening
distance of at least 3mm must be fitted upstream from the supply line
to protect from damage caused by excess current from an overload or
short circuit.
•
Contact an authorized service technician if you are unsure if you have
RCD and CB installed on the premises.
•
Do not install the heater directly near a bathtub, shower or swimming
pool. Any switches or controls must not be within reach of a person in
the bathtub, shower or swimming pool.
•
To maintain Ingress Protection Rating (IP55) for the Marine variants, only
IP55 or better rated electrical components such as switches and conduit
fittings should be used for electrical installation.
•
To maintain Ingress Protection Rating (IP54) for the Standard variants,
only IP54 or better rated electrical components such as switches and
conduit fittings should be used for electrical installation.
•
This product does not have a switch for electrical disconnection. A
means for disconnection of the heater must be incorporated in the fixed
wiring according to the local electrical codes.
!
