8
bromic.com
8. To fix heater at desired angle, fully insert M3x10mm positioning screws (included with wall bracket) on both
sides of mounting bracket whilst holding heater in the desired position
(h).
The heater can be positioned
straight, or be angled 28° either way.
9. Fit the smaller cover over the heater bracket so that the slots pass over the shafts of the M6x14mm
mounting screws
(i)
. Fit the larger cover over the smaller cover in the same way from the opposite side of the
bracket
(j)
. Use angled covers if heater is angled. Use straight covers if heater is not angled.
10. Tighten mounting M6 screws firmly, ensuring covers fit snugly against the bracket on all sides
(k).
k
Straight bracket option
j
i
h
j
h
i
k
Angle bracket option
8. To fix heater at desired angle, fully insert M4x10mm positioning screws on
both sides of mounting bracket whilst holding heater in the desired position
(h). The heater can positioned straight, or be angled 30deg either way.
9. Fit the smaller cover over the heater bracket so that the slots pass over the
shafts of the M6x14mm mounting screws (i). Fit the larger cover over the
smaller cover in the same way from the opposite side of the bracket (j).
Use angled covers if heater is angled. Use straight covers if heater is not
angled.
10. Tighten mounting screws firmly, ensuring covers fit snugly against the
bracket on all sides (k).
HEATING INSTALLATION INSTRUCTIONS
Covers (i) and (j), and cable gland (b), MUST be fitted in order to achieve
the respective IP ratings (Standard IP54, Marine IP55).
Electrical components, conduits and switches used MUST have IP ratings
equal to or better than the respective ratings of the heater in order to
maintain the heater IP ratings (Standard IP54, Marine IP55).
!
IMPORTANT
