10
bromic.com
d
f
e
/ 9.1 "
870
/ 34.2"
c
/ 9.1 "
870
/ 34.2"
NOTE: The thickness of the ceiling surface dictates which locator
hole to use. The fastening screws must be inserted into a strong
non-combustible structural members that can easily support the
weight of the heater. Your installation may require re-enforcing
before the frame can be safely installed.
3. Unscrew and remove the grey plug from the wall bracket.
Attach the supplied metal cable gland
(c)
into the same hole
from the outside of the bracket.
4. Feed heater power cable through cable gland (supplied) from
inside of wall bracket
(d)
.
5. Ensure M6x14mm screws are inserted into either side of heater
bracket with 6mm (0.3”) of the threaded shaft exposed under the
screw head.
(e)
.
6. Insert heater bracket into mounting bracket by hooking M6
screws into place in mounting slots
(f)
.
7. Fix heater to bracket in straight position using M4x10mm
positioning screws on either side of mounting bracket
(g)
. Ensure
M6 screws are sitting fully in the mounting slots (as if the heater
were hanging from the wall bracket).
8. Fit the smaller, straight cover over the heater bracket so that
the slots pass over the shafts of the M6x14mm mounting screws
(h)
. Fit the larger cover over the smaller cover in the same way
from the opposite side of the bracket
(i)
.
9. Tighten mounting screws firmly, ensuring covers fit snugly
against the bracket on all sides
(j)
.
10. Firmly tighten cable gland in wall bracket so that cable does
not move when pulled.
11. Attach the bracket end-cap to the wall bracket using the
4 x M5 screws and nuts provided
(k).
12. Carefully remove the 4 x M5 screws fastening the heater
mounting bracket to the back of the heater. Be careful not to
move or put any force on the bracket. Place the 2 halves of the
ceiling recess mounting plate over the screw holes. Re-insert the
screws & tighten firmly.
(l)
13. Make electrical connection from heater to power supply. This
is described under ‘Electrical Installation’ on page 13.
14. Raise one long side of heater up into ceiling frame cavity &
then raise whole heater into cavity.
(m)
15. Rotate the heater into level position in the ceiling cavity
(n)
and then lower down onto the ceiling frame . Ensure the heater
brackets are hooked over the ceiling frame and sitting in the slots
on both sides.
(o)
g
h
i
/ 9.1 "
870
/ 34.2"
HEATING INSTALLATION INSTRUCTIONS
k
l
j
k
j
m
o
n
CEILING RECESS KIT INSTALLATION (SOLD SEPARATELY)
b
