bromic.com
9
STEP 4 – Setting up the button codes in Docklight.
The Smart-Heat Link device can operate up to 50 controllers using pre-program codes.
The codes are stored in memory ID location 1 – 50.
The following example uses ID location 1. Refer to section “Additional Codes” for further
examples and defining additional commands.
Each remote/controller pair will need to use a unique ID location, the table below is an example
if using ID location 1 only. Refer to Code Structure and Additional Codes for details on using ID
locations 2 through 50.
Using the Docklight command interface below, program in the following transmit codes
(Green Column)
Follow the steps shown below
PROGRAMMING INSTRUCTIONS
Button #
Name
7 Button
Function
(Dimmer
Controller)
4 Button
Function
(ON/OFF
Controller)
Transmit Code
ID Location 1
1
T ID1 B1
1 -1 00%
1 – Ch 1 ON
54 00 01 00 01 56
2
T ID1 B2
2 - 75%
2 – CH 1 OFF
54 00 01 00 02 57
3
T ID1 B3
3 - 50%
3 – CH 2 ON
54 00 01 00 03 58
4
T ID1 B4
4 - 25%
4 – CH 2 OFF
54 00 01 00 04 59
5
T ID1 B5
5 - Dim up
Not used
54 00 01 00 05 5A
6
T ID1 B6
6 - Dim Down
Not used
54 00 01 00 07 5C
7
T ID1 B7
7 - Off
Not used
54 00 01 00 08 5D
