bromic.com
6
INSTALLATION INSTRUCTIONS
SETTING UP
The integration process requires
1)
Access to the installation site with controller and remote in working condition.
2)
Program the device using a PC (covered by this manual)
3)
Program the Home Automation System (by 3rd party integration).
This instruction manual will detail the steps to program the device using a PC.
The Home Automation System programming needs to be performed by the integrator (others.)
The programming requires access to the site with the controller and remote in working
condition. A PC is required to program the Bromic Smart-HeatTM Link to the controller using
the paired remote.
Before The installation
The Bromic controller remote has been pre-programmed at the factory to operate with the
supplied controller.
Check the operation of the remote and controller before beginning. Refer to the instruction
manual supplied with the controller.
IF THE PAIRED REMOTE DOES NOT WORK WITH THE CONTROLLER, THE Bromic
Smart-Heat
TM
Link PROGRAMMING STEPS BELOW WILL NOT WORK.
In this case, troubleshoot the controller and remote devices using the instruction manual
supplied with the controller. The controller and paired remotes are pre-programmed with
unique codes for each button operation.
TECHNICAL SPECIFICATION
Model
Bromic Smart-Heat
TM
Link
Part no.
For AU P/N: 2620279
For US/CA P/N: BH3130097
For EU P/N: BH3130098
Power Supply
+
5VDC
Carrier frequency
US/CA/AU
916 MHz, EU 868 MHz
Transmission Range to
Controller
30m or 100 feet
Working temperature
-10°C to +55°C (14°F to 131°F)
