EG300 Broilchef LP Gas Grill
Owner’s Manual
11
Step 10 (Assemble the grill body to the cart)
a) Put the grill body (O) on the top of cart assembly.
b) Align the two holes on the top of cart left side
panel with the two holes on the left side of body
assembly.
c) Insert one bolt (hh), one spring washer (kk) and
one flat washer (ll) into each pre-drilled hole.
Tighten bolts by hand until secure.
d) Repeat the procedure for the right side of body
assembly with right side panel.
e) Go back and tighten all bolts using the
screwdriver provided.
Attention:
Unpack the regulator/hose
assembly (located underneath the firebox)
prior to assembling the grill body to the
cart, and push the regulator/hose into the
hole on cart left side panel when go ahead
to this step.
Step 11 (Left table supports and heat insulator
assembly)
a) Turn over left table (P) and align the holes on left
table front support (Q) with the holes on bottom of
left table.
b) Insert one bolt (ii), one flat washer (kk) and one
spring washer (ll) into each pre-drilled holes.
Tighten bolts by hand.
c) Repeat the procedure for the left table back
support (R) with left table.
d) Go back and tighten all bolts using the
screwdriver provided.
Step 12 (Left side table assembly)
a) Align the holes on left side table front
support (Q) and back support (R) with the
holes on the left side wall of firebox.
b) Insert one bolt (ii), one spring washer (kk)
and one spring washer (ll) into each
pre-drilled holes. Tighten bolts by hand.
c) Align the holes on front of left side table
with the holes on the left side of control
panel.
d) Insert one bolt (nn) into pre-drilled hole.
Tighten bolts by hand.
e) Go back and tighten all bolts using the
screwdriver and wrench provided.
