Broderson IC-100-3A, Operation And Maintenance Manual

Page: 51 / 69

3-7
LUBRICATION
SWING BEARING LUBRICATION:
There is one grease zerk in a hole on the left-hand side of the turntable base plate. This
should be used to lubricate the bearing every 50 hours. Rotate the turntable about 45
degrees and pump some grease into the zerk. Repeat until the turntable has rotated two
revolutions. Use about 6 ounces (180 cc) of grease each time the bearing is lubricated.
Also, lubricate the gear teeth of the swing bearing at the 50 - hour interval. Remove the
pinion cover. Brush open gear grease, such as Mobilkote-S, on the teeth on each side
of the pinion at four places around the bearing. Rotate the boom several times and
check the coverage of the grease on all of the teeth. Replace the pinion cover.
TRANSMISSION:
Check the transmission fluid with the dipstick and add fluid through the dipstick tube as
required. Use Mobil ATF Type F or equivalent. Transmission factory service manuals
are available from Broderson. Order BMC Part Number 990-00021.
DRIVE AXLES--HUBS AND DIFFERENTIALS:
Maintain lubricant to levels shown here with Mobil 424 or equivalent.
FLUID VOLUME CHART:
HYDRAULIC RESERVOIR - 25 Gallons (95 L)
FUEL TANK - 20 Gallons (76 L)
PLANETARY HOIST - 2.5 Quarts (2.4 L)
FRONT AUXILIARY WINCH - 2 Pints (1 L)
PLANETARY DRIVE AXLE – 11 Quarts (10 L) Center Section & 0.75 Quart (.7 L) each
end.
TRANSMISSION, POWERSHIFT - 17.5 Quarts (16.6 L)
ENGINE COOLING SYSTEM - 15 (14 L) to 17 (16 L) Quarts depending on engine and
heater.