Broco Prime-Cut, Operating Instructions Manual

Page: 12 / 32

5.2.1 Slave Plug (600143)
1. Connect the power cable from the torch to the slave plug by connecting the
black Cam-Lok plug on the torch cable to the black Cam-Lok receptacle on the
slave plug.
2. Connect the striker plate to the slave plug by connecting the red Cam-Lok plug
on the torch cable to the red Cam-Lok receptacle on the slave plug.
3. Plug the slave plug into the vehicle slave receptacle.
5.3 Leather Shield (PC/LS)
WARNING!
Always use the
leather shield (PC/LS) designed
for the torch to protect yourself
from spark and splatter burns.
NOTE: Make sure the leather
shield is not between the oxygen
control lever and the torch
handle where it would interfere
with the operation of the torch.
1. Remove the collet nut from
the torch.
2. With the smooth finished
side of the shield facing away
from the torch, slide the leather
shield onto the collet nut.
3. Screw the collet nut back onto the torch.
4. Position the leather shield so the long end covers the oxygen control lever.
5.4 Cutting Rod Insertion
WARNING!
Always wear welding gloves when inserting rods into or removing rods
from the Prime-Cut torch.
Always insert the correct end of the cutting rod into the torch.
Never use a damaged cutting rod.