Flush Mount Rack Kit Installation Procedure
7 of 10
53-1002127-03
Attaching front brackets to a rack
Complete the following steps to install the switch in the rack.
1. Position the switch in the rack (
), providing temporary support under the switch until the rail kit is fully
secured to the rack.
2. Attach the right front bracket to the right rack upright using three 10-32 x 5/8-in. screws and three retainer nuts
.
3. Attach the left front bracket to the left rack upright using three 10-32 x 5/8-in. screws and three retainer nuts.
4. Tighten all the 10-32 x 5/8-in. screws to a torque of 25 in-lbs. (29 cm-kgs).
FIGURE 3
Attaching front brackets to a rack
5
Screw, 10-32 x 5/8-in., panhead Phillips
6
Retainer nut, 10-32
6
5
