Brocade NetIron CES and Brocade NetIron CER Hardware Guide
69
53-0000080-03
Replacing the fan tray
5
CAUTION
For safety reasons, the ESD wrist strap should contain a series 1 Meg ohm resistor
Removing a 2 x10-Gigabit Ethernet module
Follow the procedure given below while removing a 2 x10-Gigabit Ethernet module.
1. Power off the Brocade device.
2. Use a #2 Phillips-head screwdriver to loosen the screws on the 2 x10-Gigabit module.
3. Remove the 2 x10-Gigabit module.
4. Place the 2 x10-Gigabit module in an anti-static bag for storage.
5. If you are removing the module without replacing it, install the blank faceplate in the front
panel.
Installing a 2 x10-Gigabit Ethernet Module
Follow these procedures when installing a 10-Gigabit Ethernet Module.
1. Power off the Brocade
device.
2. Use a #2 Phillips-head screwdriver to remove the blank faceplate or old module from the front
panel.
3. Install the 10-Gigabit module in the chassis.
4. Use a #2 Phillips-head screwdriver to fasten the screws on the 2 x10-Gigabit module. Affix the
screws loosely at first, then tighten them once you are sure the board is properly positioned.
Replacing the fan tray
The Brocade devices cooling fans use pull configuration to move the air from the front to the back
of the device.
The fans in the Brocade devices include six four-speed fans that operate at low speed, medium
speed, medium-high speed, and high speed based on the ambient temperature and configured or
default temperature thresholds. All fans operate simultaneously at the same speed. If a single fan
fails within the assembly, the fan tray should be replaced. The fan tray is hot swappable.
If a Brocade device remains operational during a fan tray replacement, the procedure must be
completed within 30 seconds.
NOTE
Fan trays are hot swappable. Hot swapping fan trays should be done within 30 seconds so the unit
will continue to function correctly without any fans. However, Brocade recommends that you
disconnect the power supply from AC or DC power before installing or removing the fan tray.
Summary of Contents for NetIron CER 2024C
Page 12: ...xii Brocade NetIron CES and Brocade NetIron CER Hardware Guide 53 0000080 03 In this chapter...
Page 90: ...78 Brocade NetIron CES and Brocade NetIron CER Hardware Guide 53 0000080 03 China A China...
Page 100: ...88 Brocade NetIron CES and Brocade NetIron CER Hardware Guide 53 0000080 03 Danger B...
