Brocade Communications Systems 6910, Manual

Page: 69 / 80

Brocade 6910 Ethernet Access Switch MIB Reference 57
53-1002582-01
Chapter
13
Traps and Objects to Enable Traps
Objects for Brocade 6910 switch traps
This section present the objects available to enable or disable traps.
Trap information
The following objects provide general information on traps.
Trap receiver table
This table allows you to configure trap receivers on the Brocade 6910 switch:
Name, OID, and Syntax Access Description
snAgTrpRcvrCurEntry
brcdIp.1.1.2.1.16
Syntax: Integer Read only Shows the total number of entries that are currently in the Trap
Receiver Table. There can be up to 5 entries.
Name, OID, and Syntax Access Description
fdryTrapReceiverTable
brcdIp.1.1.10.1.1.1 None The Trap Receiver Table.
fdryTrapReceiverEntry
brcdIp.1.1.10.1.1.1.1 None An entry in the Trap Receiver Table. This table uses a running
index as the index to the table.
Reasons to use the running index scheme rather than IP
addresses:
1
The table will be Virtual Routing and Forwarding (VRF)
independent so that multiple VRFs can share the same
address type and address.
2 An index with address type and address could be
potentially 17 unsigned integers, causing parsing and
finding the next index to take much CPU time. The PDU
gets to be huge too.
3 An IP address is just another attribute, and they are
supposed to be a list of servers.
fdryTrapReceiverIndex
brcdIp.1.1.10.1.1.1.1.1
Syntax: Unsigned32 None The index to the Trap Receiver Table.
fdryTrapReceiverAddrType
brcdIp.1.1.10.1.1.1.1.2
Syntax: InetAddressType Read-create Trap Receiver IP address Type. Supported address types are:
•
ipv4(1)
•
ipv6(2)
•
ipv6z(4)
Default: ipv4