Brocade Communications Systems 6910, Manual

Page: 60 / 80

48 Brocade 6910 Ethernet Access Switch MIB Reference
53-1002582-01
Switch port information
snSwIfInfoSpeed
brcdIp.1.1.3.3.5.1.7
Syntax: Integer Read-write Indicates the speed configuration for a port:
•
s10M(2) – 10Mbits per second.
•
s100M(3) – 100Mbits per second.
The read-back hardware status are the following:
•
s10M(2) – 10Mbits per second.
•
s100M(3) – 100Mbits per second.
•
s1G(4) – 1Gbits per second.
The port media type (expansion or regular) and port link type
(trunk or feeder) determine whether this object can be written
and the valid values for this object.
Note that “writing” this variable writes the forced-mode
configuration, which is used when autonegotiation is disabled,
and has nothing to do with the current operation mode when
autonegotiation is enabled.
snSwIfInfoMediaType
brcdIp.1.1.3.3.5.1.8
Syntax: Integer Read only Shows the media type for the port:
•
other(1) – other or unknown media.
•
m100BaseTX(2) – 100Mbits per second copper.
•
m100BaseFX(3) – 100Mbits per second fiber.
•
m1000BaseTX(7) – 1Gbits per second copper.
snSwIfInfoConnectorType
brcdIp.1.1.3.3.5.1.9
Syntax: Integer Read only Shows the type of connector that the port offers:
•
other(1) – Other or unknown connector
•
copper(2) – Copper connector
•
fiber(3) – Fiber connector
This describes the physical connector type
snSwIfStpPortEnable
brcdIp.1.1.3.3.5.1.15
Syntax: Integer Read-write Indicates if STP is enabled for the port:
•
disabled(0)
•
enabled(1)
Refer to the document IEEE 802.1D-1990: Section 4.5.5.2,
dot1dStpPortEnable.
snSwIfInfoAutoNegotiate
brcdIp.1.1.3.3.5.1.19
Syntax: Integer Read-write Applies only to Gigabit Ethernet ports.
Indicates if auto-negotiation mode is enabled on the port.
•
disable(0) – The port will be placed in non-negotiation mode.
•
enable(1) – The port will start auto-negotiation indefinitely
until it succeeds.
Default: enable(1)
snSwIfInfoFlowControl
brcdIp.1.1.3.3.5.1.20
Syntax: Integer Read-write Indicates if port flow control is enabled:
•
disable(0)
•
enable(1)
Default: enabled(1)
snSwIfInfoGigType
brcdIp.1.1.3.3.5.1.21
Syntax: Integer Read only Applies only to Gigabit Ethernet ports.
Shows the media type for the port:
•
m1000BaseSX(0) – 1-Gbps fiber, with a short wavelength
transceiver
•
m1000BaseLX(1) – 1-Gbps fiber, with a long wavelength
transceiver (3km)
•
m1000BaseTX(5) – 1-Gbps copper (100meter).
•
notApplicable(255) – a non-gigabit port.
snSwIfFastSpanPortEnable
brcdIp.1.1.3.3.5.1.22
Syntax: Integer Read-write Indicates if fast span is enabled on the port.
•
disable(0)
•
enable(1)
Name, Identifier, and Syntax Access Description