Brobo FA 3000K, Product And Maintenance Manual

Page: 38 / 42

6.2.1 Noise Level
The noise level of an idling unit has been measured below 85 dBA . This complies with the Australian
Occupational Health and Safety (Noise) Regulations 1992.
Please note, saw noise levels when cutting are higher than idling. The noise level will vary according
to the sharpness of the blade. Management should make available to the Operator(s) appropriate
hearing protection as prescribed under the State Act, if necessary.
6.2.2 Power Supply
The machine uses 415 V (3-phase) power. Any unauthorised interference and / or inadequate
maintenance could put the Operator or Person Exposed at risk. A
qualified electrician should be
assigned to maintain and repair the system.
Check that the power supply cables comply with, and are operating within the acceptable range of the
saw capabilities.
Faulty, damaged or worn components must be replaced immediately.
Installation of the earthing system must comply with the requirements stated in the IEC Standards
Part 195: Earthing and Protection Against Electric Shocks 1998.
6.2.3
Lighting
Insufficient lighting during cutting would constitute a safety hazard for the Operator and Person
Exposed. For this reason, the user of the machine must have access to adequate lighting in the
working area, while also preventing dazzling illumination sources (Reference standard
ISO 8995 -
2002 ‘Lighting of Indoor Workplaces’ ).
20 August 2016 Safety and Accident Prevention 33