Brobo FA 3000K, Product And Maintenance Manual

Page: 12 / 42

3. Slide the stock material through the feeder clamp, through the saw clamp and at least 75 mm past the
blade.
4. Press AUTO CUT .
Figure 3.7 – Auto Cut Button
On pressing AUTO CUT the saw will start coming down and detect where the stock material is present and on
detection, set up this position as the cut start point so it strokes from this point only. After this procedure it will
commence cutting.
During cutting, when machine has sawn through the piece, press
SET to set the cut end point i.e. the end of the
stroke. Once set saw will only travel the minimum distance between start and end point required to make a full
cut.
These start and end cut settings will reset automatically for the next bar.
Use the following to fine tune the cutting operation:
Figure 3.8 – Fully Automatic Operation Control Buttons
On/Off Switch with
Power Light
Home/Reset to
stop auto cutting
Dual Start
(disabled during auto cutting)
Spindle RPM dial to
change blade speed
3- 100 RPM
Saw Feed Rate dial to
change saw stroking
max speed.
Dual Start
(disabled during auto cutting)
Set Stroke to set
the cut end point
End Cut Detect to enable
automatic detection of the
end of the cut.
Emergency Stop
20 August 2016 Main Functions and Operation 9