•
fanshow
•
psshow
•
historyshow
•
tempshow
•
sensorshow
Refer to the
Fabric OS Command Reference
for output examples and descriptions.
Removing a power supply and fan assembly
Complete the following steps to remove a faulty power supply and fan assembly.
CAUTION
The power supply switch must be in the off position when you insert the power supply into the chassis. Damage to the
switch can result if a live power supply is installed.
1. To leave the device in service while replacing a power supply and fan assembly, verify that the other power supply and fan
assembly (the one not being replaced) has been powered on for at least four seconds and has a steady green LED.
FIGURE 32
Removing an AC power supply and fan assembly
1.
The Brocade G630 device
2.
Power supply slot 1
3.
Power supply assembly unit
4.
Power supply assembly handle
5.
Captive screw
2. Unplug the power cord from the power supply that is being replaced.
3. Push the lever on the lower right corner of the power supply unit towards the IEC socket.
4. Remove the power supply assembly from the chassis by pulling the handle out and away from the chassis.
Removing a power supply and fan assembly
Brocade G630 Hardware Installation Guide
78
53-1005235-02
Summary of Contents for Brocade G630
