e-mail:
voice:
360.854.9559
fax:
866.783.1742
5
VAD-2 Plus Installation and Operation Manual
PROGRAMMING
Applications
Silence Monitor III. DMS III and/or LOV II alarm notification, Tower Light
malfunction and/or operation, Transmitter, Translator and/or LPFM site and Studio
security/burglar/fire/equipment alarm notification, Inexpensive remote control sys-
tem and/or remote reset (ac power reboot) of file servers, computers, etc.
Back-up program switching with optional customized firmware and hardware.
Inspection
Please examine your VAD-2 Plus carefully for any damage that may have
been sustained during shipping. If any is noted, please notify the shipper immedi-
ately and retain the packaging for inspection by the shipper. The package should
contain the VAD-2 Plus, this manual, 7 foot modular telephone cable and the 12
VAC @ 500 ma or 1 amp wall transformer.
Programming
The VAD-2 Plus can be programmed either locally using the front panel
recessed PGM button or remotely using the program access code. To program local-
ly, please following the steps below:
1 - Locate the front panel modular RJ-11 jack labeled “Phone Pgm” and plug in a
standard TT telephone
2 - Press the recessed front panel “PGM” button; the front panel “PGM” led will
illuminate.
3 – Enter the command code of the desired operation, followed by the data to be
stored or the message to be recorded. Note: Refer to pages 6 through 9
4 After entering the data or recording voice messages, press the recessed front panel
“PGM” button to exit programming mode. The “PGM” led should extinguish.
When programming remotely, you must call the VAD-2 Plus and enter the
access code. If you call and enter the un-lock security code, you cannot then enter
the access code and perform programming functions. Terminate each item pro-
grammed with the “#” (pound) key. The access code can only be entered when the
VAD-2 Plus is in a locked condition, and only programming can be done. You must
hang up to exit program mode. Multiple parameters and voice messages can be pro-
grammed remotely in one session.
The following is a list of data items that can be programmed along with the
2 digit programming code and the maximum number of digits that can be entered,
along with the factory default data. To program any of these items, press the pro-
gram button, enter the two-digit address, followed by the data. If you enter more
than the maximum allowed, the excess characters will be ignored.
Programming