e-mail:
voice:
360.854.9559
fax:
866.783.1742
4
DC-8 Plus Installation and Operation Manual
FCC NOTICE
FCC NOTICE TO THE USERS
1. UPON REQUEST ONLY, you must provide the following data to your
telephone utility company:
2.
a) Notice of intention to install or permanently remove an FCC Part 68
registered device/syste, and the FCC Registration Number. * SEE page
14 of this manual.
b) The Ringer Equivalence Number * SEE page 14 of this manual. Note
that if several devices are connected to the same line, the REN’s must not
add up to more than 4.0 (A or B). This REN figure is important to your
telephone utility company.
c) The *(USOC) jack type to be provided by the telephone utility company.
Typically this will be RJ-11C/W for single lines.
3. This device may not be used on telco-operated coin phone lines or party lines and
privately owned coin-phones, which are subject to local State regulatory policies,
and possible additional State special requirements.
4. The telephone utility company has the right to make changes to their network
which may affect the operation of your equipment, provided you are given adequate
advance written notice to permit correct operation.
5. In case of operational problems, disconnect your unit by removing the modular
plug from the telco jack. If your regular phone (or other device or system) still
works properly, your DC-8 Plus has a problem and must remain disconnected and
officially serviced or returned for repairs. If upon the above disconnection, your reg-
ular service still has problems, notify your telephone utility company that they may
have a problem. Request prompt service at no cost to you the user. If a problem is
found in premises wiring not telco-installed, you are subject to a service charge. If
a fault is in telco installed wiring, you may not be subject to a service charge.
6. Unless otherwise noted in the User’s Manual (e.g.: fuses, etc.), user may not
under any circumstances (in or out of warranty) attempt any service, adjustments or
repairs on this unit (NO USER SERVICEABLE PARTS). It must be returned to
Broadcast Tools, Inc. for all such work. Broadcast Tools, Inc. address and phone
information is listed on page 3 of this manual.
7. Special FCC rules apply to equipment connected behind a PBX or KTS.
NOTE:
Items above flagged
with * are noted in this
manual and on the
equipment’s FCC
Compliance label.
