Maintenance
B125 06/16 Rev.1
TOPAS E350V-E600V
22
ATTENTION!
Pump damage!
The use of unsuitable oil can lead to the destruction of the pump. With the use
of unsuitable oils, you and/or your supplier bears the responsibility.
Only use the oil listed here with the indicated specification!
Performing the oil change
:
Switch off the pump and leave it to cool down.
Fig. 8 Changing the oil
1. Oil filling opening
2. Oil sight glass
3. Oil drain valve with drain tap.
Open the oil drain valve (3) and allow oil to drain out of the pump. Lift up the
pump (tilt it) a little on the motor side to speed up the drainage process.
Then close the oil drain valve (3) again. Fill up the emptied pump with new oil via
the oil filling opening (1) up to the middle of the oil sight glass (2), amount of oil
10 l. Then reclose the oil filling opening with the screw cap.
After startup, check the oil level again and fill up higher if necessary.
DISPOSAL OF OLD OIL!
Oils and fats must not get into the environment. Adhere to the regulations on
the disposal of lubricants.
