Brivo ACS300 Installation Manual
© 2019 Brivo Systems LLC. All rights reserved.
P-MAN-PUB-Brivo ACS300 Installation Manual
15
there is still a problem with the power indicator, refer to the Diagnostic LED table below.
If still unable to resolve the issue, contact Technical Support.
State #
Diag 1
Diag 2
Diag 3
State Meaning
1
OFF
OFF
OFF
All off indicates no diagnostic codes, everything is OK
2
OFF
OFF
ON
No IP Address
3
OFF
ON
OFF
Unable to reach Brivo Server
4
OFF
ON
ON
Time not known
5
ON
OFF
OFF
Rebooted within the last hour
6
ON
OFF
ON
Internal Fault within the last hour
7
ON
ON
OFF
File corruption detected. Device is damaged but still aware enough to indicate
it cannot function properly
8
ON
ON
ON
Device not registered/configured
ACS300 Diagnostic LEDs
NOTE:
When an ACS300 is experiencing any issues shown on the ACS300
Diagnostic LEDs table above, the diagnostic LEDs will display each issue for two
seconds. The last issue displayed on the LEDs will display for an additional five
seconds before the cycle starts again.