ENGLISH
OPERATION MANUAL
BRITEQ
®
7/12
BT-THEATRE 200TW
•
[SILENT]:
the fan speed will always be low to reduce fan noise to a minimum. However, this means that
the LED temperature could become too high: in that case the LED current will be reduced automatically
to protect the LED. Light output will also be lower.
•
[HIGH]:
the LED will be well cooled so maximum light output can be guaranteed under all conditions.
However, this means that fan noise will be higher than usual.
•
Press the [ENTER] button to save the setting.
LED TEMP
Used to check the LED-temperature
•
Press the ▲/▼buttons until the desired function is showing on the display and confirm with [ENTER].
•
Press the [ENTER] button to toggle between Celcius [°C] and Fahrenheit [°F].
DEFAULT
This is your emergency exit if you really messed up the settings: just return to the [Factory Settings]
(Factory Settings). Also, a user setting can be saved/loaded.
•
Press the ▲/▼buttons until the desired function is showing on the display and confirm with [ENTER].
•
Use ▲/▼ buttons to select:
•
[Factory]:
standard factory settings.
•
[USER Def.]:
you can adapt the factory settings and save the new parameters as your personal USER-
settings.
•
Press the [ENTER] button:
•
[Factory Settings] was selected:
the display shows “LOAD”
•
Press the [ENTER] button and use ▲/▼ buttons to confirm YES / NO
•
Press the [ENTER] button to confirm.
•
[USER Def.] was selected:
the display shows “LOAD”
•
Use
▲/▼ buttons to select LOAD / SAVE
•
Press the [ENTER] button
and use ▲/▼ buttons to confirm YES / NO
•
Press the [ENTER] button to confirm.
•
[SAVE] was selected:
the current settings of the setup menu are saved to memory.
•
[LOAD] was selected:
the previously saved settings are loaded.
Set of Factory default settings:
PARAMETER name
FACTORY defaults
USER defaults
[CH. MODE]
1CH 8b
Current setting in the menu
[NO DMX]
FREEZE
Current setting in the menu
[LOCKING]
OFF
Current setting in the menu
[DIM CURVE]
SQUARE
Current setting in the menu
[BEHAVIOR]
HALOGEN
Current setting in the menu
[FAN SET]
AUTO
Current setting in the menu
[DISPLAY BLINK]
ON
Current setting in the menu
[LED CCT]
3000K
Current setting in the menu
[PWM FREQ]
1.2 kHz
Current setting in the menu
[LED TEMP: C/F]
CELCIUS
Current setting in the menu
FIRMWARE
Shows the current firmware version in the projector.
•
Press the ▲/▼ buttons until the desired function is showing on the display.
•
Press the [ENTER] button: the display shows the firmware version.
Note: The firmware of this unit can be upgraded using our special
“Firmware Updater 2” (separately available
from Briteq). More information about this can be found in the user manual of the firmware updater or our
website: https://briteq-lighting.com/firmware-updater-2
CALIBRATION
In this hidden menu, you can compensate the differences between the LEDs of different batches.
NOTE: Calibration was already performed at the factory, so this function is only required for service
purposes.
•
While you are in the SETUP menu: press the [ENTER]-button during 2 seconds: calibration starts while the
light output is set to 100%.
•
Measure the light beam with a spectrometer: 4400K should be measured.
•
Measured CCT <4400K:
turn the encoder to reduce the WW-value until CCT = 4400K.