ENGLISH
OPERATION MANUAL
BRITEQ
®
10/12
BT-THEATRE 200TW
OPERATING INSTRUCTIONS
Note:
when the projector is switched on the display shows “UPDATE WAIT …” This message informs you that
IF you want to upgrade the firmware, you should do it while this message is shown on the display. For normal
use you can ignore this message completely.
A. Standalone 1unit
– Manual operation:
•
Just connect the projector to the mains.
•
In the setup menu the option [NO DMX Mode] should be set to [MANUAL]
•
Adjust the encoder
•
Refer to point 11 in chapter DESCRIPTION for more information.
B. Controlled by universal DMX-controller (wired or wireless):
•
Connect all units together. Refer to the chapter “Electrical installation for two or more units in DMX-
mode” to learn how to do this (don’t forget to address all units properly!)
•
Connect all units to the mains and turn on the DMX controller.
Since each unit has its own DMX-address, you can control them individually. Remember that each unit
can use a different number of DMX-channels, depending on the DMX-mode you have selected in the
menu.
See the different DMX charts: