Britax MULTI-TECH, Manual

Page: 11 / 80

9-25kg
4f
2
1
4
3
4h
1
2
4i
Loop a tether strap around the front
passenger seat as shown
(dia 4f) .
If your car is equipped with a runner loop
on the seat runners, these may be used
as an alternative
(dia 4g inset) .
IMPORTANT - Do not install the tether
straps using the luggage loops.
Slide the loop ends of the tether straps between the front car seat and back
as shown
1
(dia 4h) . Bring the buckle ends of the tether straps around the
outside of the car seat and feed through the loops
2
.
Slide the buckle ends under the seat. Making sure that the footprop tether
brackets are facing forward and that the straps are not twisted, snap the buckle
of the tether straps onto the tongues on the sides of the child seat
3
. Tighten
the tether straps by equally pulling the loose ends downwards
4
.
Pull the footprop away from the back of the child seat as far as possible 1
(dia 4i) . Whilst maintaining the correct angle, lower the footprop until it touches
the floor 2 . Make sure that the footprop is securely locked in place by pulling
the sliding section of the footprop.
Finally ensure that the tether straps are fully tightened by pulling the loose
ends downwards
(dia 4j) . The footprop must rest on a solid floor, not on the
lids of storage boxes or similar, at an angle of 100° to the horizontal (dia 4j) .
Use the angle guide on the back page of this user guide to check the angle of
the footprop to the floor.
Once firmly strapped in, test the child seat by trying to move it back and forth
and side to side. If it seems loose or if the footprop is not at 100° to the floor,
you must re-install until firmly installed at the correct angle.
To fit your child in the child seat refer to dia 5f .
100°
80°
4j
4g
MULTI-TECH_Draft2.indb 13 MULTI-TECH_Draft2.indb 13 19/09/2008 10:22:18 19/09/2008 10:22:18