Britax MULTI-TECH, Manual

Page: 10 / 80

4. Installing your child seat (rearward facing) in front seat
Open both lock-offs. Pull off sufficient
lap and diagonal belt (
approx. 600-
900mm ). Feed the belt through the
lock-off belt guide on the side opposite
to the buckle and in to the belt tunnel
(dia 4b) . There are two access slots in
the seat cover to aid feeding of the belt
through the belt tunnel and underneath
the seat cover
(dia 4b inset) .
Feed the seat belt through the belt
tunnel and lock-off on the opposite side
and attach the tongue into the buckle
IMPORTANT - The child seat MUST only be used with a lap or a lap and diagonal
seat belt (approved to UN/ECE regulation no. 16 or equivalent standards).
IMPORTANT - Do not use any load bearing contact points other than those
described in the instructions and marked in the child restraint.
DO NOT under any circumstances use a rearward facing child seat on a
passenger seat fitted with an active airbag.
Push the vehicle front seat back to accommodate the child seat ensuring that any
passenger directly behind will still be able to sit in a comfortable position.
With the footprop adjusted to the shortest length, place the child seat rearward
facing with the swinging base resting against the back of the vehicle seat
(dia 4a) .
IMPORTANT - DO NOT rest the back of the child seat on the dashboard or close
to the windscreen.
4a
4c
Pull all the seat belt slack through the child seat ensuring the seat belt is not
twisted. When the belt is as tight as possible, close the lock-off on the seat belt
buckle side, ensuring that both the lap and diagonal sections of the belt are
secured by it
(dia 4d inset) .
Close the lock-off on the opposite side, ensuring that only the lap section of the
belt is secured by it
(dia 4d) .
Ensure that both lock-offs have been clicked into place.
If the buckle now lies in the position marked as wrong with a and the seat
belt cannot be correctly tightened (dia 4e) , try another seating position in the
car.
4e
4b
4d
MULTI-TECH_Draft2.indb 12 19/09/2008 10:22:17
Feed the seat belt through the belt tunnel
and lock-off on the opposite side and
attach the tongue into the buckle
(dia 4c) .
83092_Reprint_Page 15/12/2008 13:04 Page 1