Britax MULTI-TECH II, User Instructions

Page: 29 / 131

9-25kg
IMPORTANT – The child seat MUST always be used with a lap belt and diagonal belt
(approved according to UN/ECE Directive No. 16 or relevant standards).
IMPORTANT – Do not use any carrying points other than those described in these
operating instructions and those labelled in the child restraint equipment.
NEVER
install a child seat backwards on a vehicle seat that is equipped with an
airbag.
Slide the front seat back in order to create space for the child seat, but only so far
that the passenger sitting behind it can still sit comfortably.
Place the child seat with the support leg in the shortest position backwards on the vehicle
seat, so that the rocking base is lying against the back of the car seat.
(Fig. 4a) .
4f
Lay the fastening belt around the
passenger seat as illustrated in
(Fig. 4f) .
If your car has an eyelet in the glide rail
of the set, this can alternatively be used
(Insert in Fig. 4g) .
IMPORTANT – Do not install the
fastening belts with luggage straps.
Loop the end of the loops of the fastening belts around the seat in front and
back again, as illustrated
1 (Fig. 4h)
. Put the ends of the fastening belt
toward the outside of the vehicle seat and guide them through the loops 2 .
Guide the tightening ends under the seat. When the support leg brackets
are pointing to the front and the belts are not twisted, lock the buckle of the
fastening belt into the tongues on the sides of the child seat
3
. Tighten the
fastening belts by pulling the loose ends downwards evenly
4
.
Pull the support leg as far away from the back of the child seat as possible
1 (Fig. 4i) . Lower the support leg as far as the floor, maintaining the correct
angle 2 . Move the support leg and ensure that the support leg is secured.
Finally, ensure that the fastening belts are fully tightened, by pulling down
on the loose ends
(Fig. 4j) . The support leg must be resting on solid ground
and not on the flaps of storage compartments or similar, at an angle of 100°
to the horizontal (Fig. 4j) . Use the angle measurer on the last page of these
operating instructions, in order to check the angle of the support leg against
the floor .
Check whether the child seat is firmly installed by moving it back and forth,as
well as sideways. If it is loose or if the support leg is not at an angle of 100° to
the floor, you will need to reinstall it, so that it is secured at the correct angle.
Put your child into the seat according to Fig. 5f .
4g
2
1
4
3
4h
1
2
4i
100° 80°
4j