Place the base in a rear facing position on the
vehicle seat.
Open lock-off by lifting both tabs, then
opening lock-off plate (Fig. B).
Pull to fully extend vehicle belt.
Route vehicle belt under both belt guides
(Fig. C).
Verify that the vehicle belt is not twisted, then
buckle.
Adjust recline by turning knob on front of
base until correct angle is achieved.
When correctly reclined, the red line on base will be level with the
ground.
If there is a problem achieving the proper recline angle, collapse the
recline adjuster and place a rolled towel or pool noodle in the crease
of the vehicle seat to help level the base.
1.
2.
3.
4.
5.
6.
•
•
Lap Belt Installation
Figure A illustrates a typical rear facing lap belt
installation with the restraint attached.
If attached, remove restraint before installing
base.
When not in use, always store the LATCH connectors
on storage ring at front of base.
•
•
•
Base Installation
24
B
A
C
WARNING!
Do not install this
restraint using an Emergency Locking
retractor (ELR) vehicle belt.
